CGP Electronics TPP-24 Manuel d'utilisateur télécharger pdf (Page 20)

CGPrint User’s Manual 20

registered in an address already in use, existing data

is cleared and the newly entered data becomes valid. If

more than 8 characters are registered, all existing

character registration is cleared.

[Address setting]

Specified address is matched to the character code

and can be accessed likewise to the stored fixed

character record. If a fixed character is defined in the

specified address, the fixed character becomes invalid.

A1 signifies the starting address for the registration

and A2 is the ending address.

[Method of data transmission]

d-1. Single character registration

Select the address to be defined (character code)

from among 20H to FFH and designate as A1.

When registering a single character, starting and

ending addresses match each other. That is,

A1=A2.

Example: A 6x8 dot matrix full dot pattern is to be

registered in address 41H (code for the fixed

character "A").

1Bh 26h 41h 41h FFh......FFh

ESC + & + n1 + n2 total 6 data

In the successive controls, a 6x8 dot matrix full

dot is output whenever the character code 41H is

specified. (Character "A" cannot be accessed.)

d-2. Multiple character registration

By repeating the single character registration, a

maximum of 3 characters can be registered.

When defining multiple characters in a

successive address (character code), register

pattern data for a maximum of 8 characters by

designation A1 as the starting address and A2 as

the ending address.

Note: A1< A2 and A2-A1  2

1 2 ... 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

CGP Electronics TPP-24 Manuel d'utilisateur Page 20